No hay artículos en el carro
No hay artículos en el carroJeremy Leahy
Comentado en Canadá el 26 de febrero de 2025
A little cheap feeling, but good for the price
Stay at Home Mom in California
Comentado en los Estados Unidos el 8 de abril de 2025
Bought to replace an old toilet paper holder.There was a piece of wood in the wall from the old holder and I didn’t need to use the spring and bracket. I just screwed it right in and it worked perfectly.But it worked beautifully. I like the look. It’s a huge improvement! It holds mega rolls (shown in picture) with no issues .
Alma Diaz
Comentado en México el 15 de julio de 2024
Se ve muy bonito. si lo recomiendo
Kristine
Comentado en Canadá el 13 de diciembre de 2024
The two pieces on the outside of the toilet paper holder do not properly fasten and are loose and therefore don't allow the bar to sit in between them. Currently trying to find new screws or a different solution...
Customer
Comentado en los Estados Unidos el 21 de julio de 2023
I was really tired of smacking my knee into the toilet paper holders in my bathrooms. I have 2.5 baths in the house and the contractor originally installed them really low and directly in the path of a knee cap!I saw these on Amazon and figured I would give them a shot. When they arrived, I was pleasantly surprised by the high quality packaging and the quality of the metal and finish! These are solid brushed metal as is described in the ad. The finish and hardware is high quality and is not difficult to install. The only thing plastic on these units is the toilet paper roll (as is to be expected). Even the two sides where the roll attach are machined metal!Installation:Since it requires a 5.25” square hole in the wall, I decided to use a 5 1/4” floppy disk as my template. 😅I traced around the “template” and cut the hole with a razor box cutter. Afterward I placed the spring and bracket into the wall which fit easily and snugly. On my first attempt installing the holder, I bumped the bracket and knocked it into the wall so it fell down to the floor, inside the wall. Easy enough….I grabbed a magnet and attached some yarn to fish it back out.Second attempt I started the screws a few turns and then used the electric drill to finish tightening. I would not recommend tightening TOO much as it might strip out the metal and make it fall but I was able to get it very tight against the wall. The unit has no budge or give at all. It feels like it’s against a stud in the wall, even though it’s free hanging.This whole install process took me around 10 minutes and it looks incredible with the brushed steel finish. I highly recommend these units for anyone looking to have an industrial toilet paper holder in the wall that looks fantastic! 😎👍
stephan filiatreault
Comentado en Canadá el 7 de agosto de 2021
facile d'installation bon produit
Productos recomendados