No hay artículos en el carro
No hay artículos en el carroTamiya America, Inc Modeler's Side Cutter, TAM74093
Stu
Comentado en el Reino Unido el 24 de julio de 2024
Wish I had brought these years ago,much better than normal side cutters. Parts are removed from sprues with minimal clean up required. Highly recommended.
Cyril Bernard Relota
Comentado en Alemania el 30 de enero de 2024
Good product
Customer
Comentado en Canadá el 27 de octubre de 2023
Great product if you’re just starting out in plastic modelling!
Kerry
Comentado en los Estados Unidos el 26 de enero de 2021
This is my first set of legitimate sprue cutters but I have to say I wish I had purchased the Tamiya cutter years ago. In the past, I removed parts from sprues with either a knife or small scissors. Both tools did remove the parts but too many times they also launched smaller parts into the part eating carpet where they were never seen again. I like the Tamiya cutter because the cutting edge is angled flat on one side which allows for a clean, snapless cut that often leaves the part clean of any residual plastic requiring clean-up. I count this among my essential modeling tools.
jean-claude
Comentado en Francia el 23 de septiembre de 2016
Très bonne pince coupante à la coupe propre et précise.Outil léger et facile à utiliser, permet de couper même les plus petites pièces facilement.
Productos recomendados
Mex $255.05
Mex $ 145 .00 Mex $145.00
Mex $284.99
Mex $ 165 .00 Mex $165.00