Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

Varilla de soldadura de plástico HDPE de polietileno de alta densidad, 1/8 pulgadas de diámetro, 50 pies, natural

Envío gratis en pedidos superiores a Mex $600.00

Mex $379.01

Mex $ 185 .00 Mex $185.00

En stock
  • Varillas redondas de 1/8"
  • plástico HDPE 2
  • 50 unidades, 1 unidad = 12 pulgadas
  • Alta resistencia al desgaste, alta resistencia a la inadherencia, resistencia a bajas temperaturas
  • Propiedad no tóxica y limpia, buena autolubricación


Varilla de soldadura termoplástica, polietileno de alta densidad
Diámetro: 1/8 pulgadas.
Color: natural.
Cantidad: 50 unidades/caja.
1 unidad = 12 pulgadas.
Rango de temperatura de 500 grados a 600 grados F


P. Buchanan
Comentado en los Estados Unidos el 28 de marzo de 2025
These worked pretty well for my water tank repair, and the water holds great. The only surprise was that it seemed I had to heat up the airflow more than usual to melt them. They were priced right, and I feel they could be a bit thicker gauge, but overall I'm quite happy with the results.
Real Nault
Comentado en Canadá el 18 de noviembre de 2024
Je recommande
JT
Comentado en los Estados Unidos el 1 de noviembre de 2024
Didn't have to use any reinforcement screen or staples (tried it this way first). Worked great with this HDPE rod. Filled a 1/4 inch wide by 1 inch long hole that was all the way through the tank. Used 1 rod. Fixed a pressure tank garden sprayer fast and easy. Holds full pressure now.
Ian Hendry
Comentado en el Reino Unido el 17 de abril de 2024
The HDPE welding rods worked fine and repaired the broken wheelie bin lid hinge.Very pleased with the product
Edward
Comentado en México el 22 de junio de 2023
fácil de usar se vuelve transparente cuando se calienta no tiene olor
Rewire2000
Comentado en Canadá el 20 de junio de 2023
I'm not used to plastic welding. There isn't any colour change similar to welding aluminium. It holds the heat so you need to let the piece cool down a bit. I just used my soldering iron with a flat wide tip. I'm not sure if a hot air gun or a plastic welding iron would work better. I welded a hole in my water softener tank from a sharp stone that it had been sitting on for years. The first try didn't work so I went over it again and also did the inside. That's been holding so far. This was my first try at using these rods but it's good to know that I have an option for hdpe problems.
Productos recomendados

Mex $1,168.23

Mex $ 572 .00 Mex $572.00

4.7
Elegir

Mex $999.76

Mex $ 529 .00 Mex $529.00

4.9
Elegir