No hay artículos en el carro
No hay artículos en el carroMás información del producto
Jeffrey D.
Comentado en los Estados Unidos el 12 de diciembre de 2024
Very poor quality- would not recommend at all
Walt Dennig
Comentado en los Estados Unidos el 3 de octubre de 2023
I don't use this as a seamer, but rather a small hand brake. It works well for small sheet metal projects, like flashing.
eva kasachev
Comentado en Canadá el 28 de noviembre de 2019
Works great. Good quality
Arby
Comentado en los Estados Unidos el 30 de octubre de 2019
I see only two things I would change. First, the spring is stupid strong. Much stronger than warranted and unnecessarily increases the difficulty of operating the tool. Second, the jaws open too wide and there is no adjustment. When opened wide, the jaws and handles spread a bit too far which further increases the difficulty in using the tool. Ergonomically, the spring and handles are an issue. Change the spring, adjust excessive opening and handle spread, and it's a solid and lifetime tool.
Richard
Comentado en los Estados Unidos el 1 de enero de 2017
I am a contractor and for years I used a hammer, board and pliers to do the small flashing details I needed. I purchased a pair of these a some years ago. My son-in-law a contractor also which does a lot of work with me was always was borrowing mine so I had to get him some this Christmas. They are a must have if you are doing on site bending of flashing. It is never as good as a sheet metal shop with the bigger machines to do the job but it is great for the time when you do not need them.
t.a.
Comentado en los Estados Unidos el 23 de abril de 2017
Heavy in the hand and bull strong , so far so good . I use it to straighten out the four by four squares of wire after installing goat and sheep fence . The 3 inch fits in the 4 inch squares and straightens out the wire that gets bent in shipping , handling and installation . Just put on the bent horizontal or vertical wire and squeeze as you turn it . Don't have to squeeze hard as the wire is soft and it is factory straight and square . Makes for a first class fence job ! I like this tool and it is worth the price paid . Rubbed a little 3N1 oil on it and put it in the tool box . Should last for years . Thanks for reading !
Productos recomendados