No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Especificaciones:
Profundidad de perforación de 14 pulgadas en hormigón, hormigón con barras de refuerzo o mampostería dura.
Uso solo en modo rotativo, no utilices el modo de martillo. Se adapta a tamaños de eje roscado de 1-1/4"-7.
Usar solo húmedo.
Materiales aplicables
wael aljalb
Comentado en los Estados Unidos el 19 de marzo de 2025
This is very bad from the first use. I do not recommend buying it
Justin Wiebe
Comentado en Canadá el 1 de enero de 2025
Good for a few holes. Might get like 20 or so in 6” slab depending on how much bar your passing through.
Absolute
Comentado en los Estados Unidos el 1 de septiembre de 2024
Worked great minus being red. It's metal underneath and wish that I would have stripped the paint off before it went down my drywall. Second coat of paint and all good.
Cynthia
Comentado en los Estados Unidos el 21 de agosto de 2023
If using a standard drill, Make sure you have a big spray bottle of water. Every 15-20 seconds, pull out the bit, spray the hole, and repeat!
Jerry Day
Comentado en los Estados Unidos el 1 de mayo de 2022
I used this to cut through my concrete to run a sewer pipe. This hole saw worked well. You must keep it very wet or it will get stuck. As I was getting deeper, the cutting became slower, I think the diamonds were wearing out. You need to remove and disassemble it, take a bar and knock out the concrete from inside of it routinely. Also you need a good grinder as it takes a lot of torque to cut through. I burned up 2 grinders on this project. This is a great product for a one time use.
Productos recomendados
Mex $385.74
Mex $ 177 .00 Mex $177.00
Mex $3,290.99
Mex $ 1,349 .00 Mex $1,349.00