No hay artículos en el carro
No hay artículos en el carrotony acquaro
Comentado en los Estados Unidos el 17 de marzo de 2025
Do not buy these they don’t work the hole for the tie rods taper is wrong and tie rods bind up and you can’t steer the spindle shaft is also the wrong size it’s to long the fitter pin does not match up to the cake nut
Bruce
Comentado en los Estados Unidos el 10 de enero de 2025
Rub on upper an arm, put ball joint on bottom of a arm or grind. Could not tighten rotors without adding shims between the spindle nut washer and bearing. They are not BellTech
norman dupont
Comentado en los Estados Unidos el 11 de diciembre de 2024
They work fit easy to install
Wayfastwil
Comentado en los Estados Unidos el 27 de noviembre de 2024
Well made product needing a small amount of clearancing you could do it with a Dremal to
Luis lulu
Comentado en los Estados Unidos el 15 de enero de 2024
This product it's not a bolt on, there are parts that bind, you will have to modify either the upper control arm or the part it self, the original bolts are metric for the dust cover and speed sensor but on the spindle they are all standard 5/16 thread. The milling is not correct one of the spindle grooves was not milled to accept the washer and did not fully seat to preload the bearings. Not satisfied at all, I have modified and milled the spindle to make it work properly, in all I have spent 4 to 5 hours on mods and finding fasteners to make it work in all im satisfied with the height and that's all im satisfied with.
Productos recomendados
Mex $3,721.95
Mex $ 1,637 .00 Mex $1,637.00
Mex $2,960.26
Mex $ 1,450 .00 Mex $1,450.00
Mex $1,418.63
Mex $ 581 .00 Mex $581.00
Mex $871.45
Mex $ 392 .00 Mex $392.00
Mex $1,657.96
Mex $ 696 .00 Mex $696.00
Mex $1,375.20
Mex $ 591 .00 Mex $591.00
Mex $899.85
Mex $ 440 .00 Mex $440.00