Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

LUYE Conectores de bajo voltaje para luces de paisaje, conector de cable de bloqueo rápido, para exteriores, iluminación de paisaje de bajo voltaje, luces de camino (paquete de 16)

Envío gratis en pedidos superiores a Mex $600.00

Mex $275.49

Mex $ 157 .00 Mex $157.00

En stock

Acerca de este artículo

  • Conectores de cableado de paisaje de bloqueo rápido: paquete de 16 clips de conectores de cable para exteriores LUYE con diseño mejorado de apriete a rosca, suficiente para instalar rápidamente 8 unidades de luz de paisaje de bajo voltaje al aire última intervensión o reemplazar el conector defectuoso, más confiable que el conector estilo empuje o pellizco
  • Plástico de nailon ultra fuerte y pin afilado de cobre niquelado: el empalme de alambre de bajo voltaje está hecho de plástico de nailon resistente, pines de latón niquelado, conectores de alambre bien construidos que garantizan resistencia a la corrosión y conductividad eléctrica para el hogar y el proyecto de alambre de paisaje de bajo voltaje al aire última intervensión utilizando
  • Amplia aplicación para exteriores: combinación perfecta para cables de calibre 12 y 14 de iluminación de paisaje de bajo voltaje. Reemplazo perfecto para otros conectores de cable
  • Fácil de instalar: sin engarzar, sin cortar, sin empalmar. Gran diseño mejorado y mecanizado de alta calidad garantizan conexiones fiables durante años. Solo toma 3 minutos para conectar tus luces de paisaje fácil y rápidamente
  • Servicio posventa premium: si tienes algún problema con tu conector de cable de bajo voltaje, ponte en contacto con nosotros



Descripción del producto

Conectores de cable

Conectores de cable

2

conectores de cable

2

conector de cable

conector de cable

LUYE

Demetri
Comentado en los Estados Unidos el 5 de febrero de 2025
Having used an assortment of low voltage connectors, these have proved to be the best, mostly because of their simplicity and ease of affixing 12 gauge wire to lighter gauge wire leads of the outdoor lamp.
NJGUARDIAN
Comentado en los Estados Unidos el 22 de diciembre de 2024
I bought the low voltage connectors as the are the same type that came with the low voltage landscape lighting I installed. They are a very good and easy connector to use. I wanted to ensure there was no way for moisture to get into the connector so after connecting and testing the lights I sealed the entire connector in liquid electrical tape (this is probably unnecessary). After about a week of using the lights I realized that I needed to relocate two. Since they were “sealed” I was unable to reuse the original connectors and ordered these as replacements and extras should I decide to change the lighting layout in the future. (I just cut the wire leading to the original position and leave that connector in place and dip the cut end in the liquid electrical tape to seal it. Works great!
Nicholas M Hamon
Comentado en los Estados Unidos el 5 de septiembre de 2024
Quick to install and make a better connection than the connectors most original landscape lights used to come with
Chase Scott
Comentado en los Estados Unidos el 14 de octubre de 2023
These connectors are value priced and work well . Easy to install , appear durable , and are a good value . I do like the single connectors that are quicker when installing as they clamp into both lines at the same time but cost wise these are less expensive and still get the job done .
Sharon Westfall
Comentado en los Estados Unidos el 7 de septiembre de 2023
I'm redoing my lights from about 20 years ago. The old system used these larger vampire clamps with 2 blades that pierce the wire. They did fairly well over the years, but were always hard to use and flaky.These connectors are MUCH more robust! They attach well and provide a secure connection on most wires. I struggled to get these to connect properly to my 12 gauge trunk lines. The 12 gauge wires spread the 2 halves of the connector, making it hard to screw down the other part without cross threading. On 14 gauge wire I had no such difficulty--except when I got really tired.The part you attach the lights is the smaller end and works well with most of the lights I bought. They do not work well with 22-24 gauge wires, like one set of lights I bought. For those, I had to solder on feeder lines that will then feed into these connectors. Just loosen the small end and jam the wire from your light into it. Push until you feel it seat really well, then screw down the cap. Give it a little tug to make sure it's seated firmly, and you're good to go!
Productos recomendados

Mex $186.99

Mex $ 99 .00 Mex $99.00

4.8
Elegir