No hay artículos en el carro
No hay artículos en el carroMark S.
Comentado en los Estados Unidos el 30 de marzo de 2025
Bought as security screws for my new taillights. Make it harder for the average taillight theif to make off with my stuff is usually enough to make them move on.
Marc K
Comentado en los Estados Unidos el 1 de marzo de 2025
(Many) Tesla vehicles use 6mm 5M screws for the rear license plate. If you add a frame, then you'd need 8mm screws to account for the extra thickness. But if you have one of those fancy silicone license plate frames and a clear protector, 8mm won't cut it; you need 16mm. Now you can tell this isn't being marketed for license plates because it's a pack of 50, not 4 or 8. But they worked great for an over-the-top Tesla license plate setup. They are stainless steel, which should protect from rust, and they require a torx security bit to install and uninstall, which should protect from a casual thief (but probably not a dedicated thief). The head is kind of small. So by themselves they would go right through the typical license plate hole. But if you're at the point that you need these screws, you'll also be using screw caps and those will provide the extra diameter to keep the screws from passing through the mounting holes.
Customer
Comentado en los Estados Unidos el 8 de abril de 2025
good quality
Maravilla
Comentado en los Estados Unidos el 8 de abril de 2025
I needed an M6 bit and new bolts/screws for my scooter kick stand.It was a perfect fit. These have a black coating on them and I don't expect any rust issues. The quality is good, not bad, but nothing special either.The key reason why this is important is because this is a security bit which has a pin/hole in the middle to prevent most people from easily stealing your license plate or something you are trying to protect since it's less common than a philips screw. Great functionality.
Mike.G
Comentado en los Estados Unidos el 2 de abril de 2025
The threads on these bolts are course and deep and are full threaded (i.e. the threads go the entire length of the shaft) which makes them able to be tightened all the way down to the bolt's head. I'm using these with rivnuts to assemble an all metal shed that requires various lengths and thicknesses. Included with these screws is a Torx screwdriver bit that must be used to insert or remove the screw. I use these Torx screws on the hinges and clasps making it more difficult for someone to remove the screws without the Torx bit.
Productos recomendados
Mex $250.00
Mex $ 145 .00 Mex $145.00
Mex $140.57
Mex $ 82 .00 Mex $82.00