No hay artículos en el carro
No hay artículos en el carroMás información del producto
Original Arch Light Blocking Shade
The Look You Want Without the Work
Temporary to fully custom. Paper to artisan fabric. Quick fix to fashionable fixture. Redi Shade helps you make the smartest choice for your window coverings by providing a full range of high-quality options — all with a no-tools approach to installation.
- Redi Shade, covering windows for 25 years
Original Arch Light Blocking Fabric Shade
By Redi Shade
Get a custom fit and finish for a fraction of the cost with Redi Shade’s Original Arch Light Blocking Fabric shade.
Designed for perfect half-rounded arch shaped windows, this pleated shade provides near maximum privacy while blocking heat, sunlight, and UV rays.
No tools needed for installation. Just trim at home for a perfect fit inside the window, then peel and place for permanent installation – no drills, screws, or brackets needed.
These light blocking fabric shades are available in white and natural colors and are made from non-woven polyester with heat reflective layer.
- Custom Fit:Trim at home to fit in perfect half-round arch windows
- No Tools Installation: Peel and stick for permanent installation – no drill, screws or brackets required
- Privacy and Light Control: Block out heat, sunlight, and UV rays while enjoying privacy and light control
- Heat Protection: Made of non-woven polyester fabric with added heat reflective layer
- Match Decor: Customize the Original Arch at home with fabric or paint to match decor
No Tools Needed for Installation
Step 1
Trim for a perfect fit.
Step 2
Peel to remove liner.
Step 3
Stick to permanently install.
Kim
Comentado en los Estados Unidos el 8 de agosto de 2024
For my previous house, I had purchased arch window shades for $100+ for each window. This time, I decided to try these out first. They were simple to install. There’s wiggle room if you cut them correctly. Remember to sharpen your knife before you start. I did 3 windows. Pics are from the first window I did. First window required me to cut the shade 3x, 2nd window, I had to cut it 2x, and the last one only required 1 cut.For me, it was better to be safe than sorry. Anyway, my arch wasn’t a “perfect arch size.” The window pictures displayed size was 67 1/2 x 33. So doubling the height would’ve only gotten me to 66” and the directions want you to take of 1/4”. In regards to the measurements, I cut it to 65 3/4. Make sure you center the plastic stand in the center. I used some clear shipping tape to keep it steady. From there I fanned it out and it was a perfect fit (remember I cut it 3x on my first try.) Here comes the wiggle room. I stretched it out to reach the end of the arch before actually taping it down and did the same for the other side. Keep in mind that the length was 67 1/2 but I had to trim it to 65 3/4 to fit the height. Voila!! Perfect arch!Make sure you clean the sill very well to ensure adhesion. Also, please note that one side is white (a bit shiny like it’s laminated) and the other side is like a fabric gray color. It looks a bit ombré because it’s so dense at the base. It appears to be quite sturdy and should last for a good long while. It actually looks better in person. I promise! ; )
Joe
Comentado en Suecia el 17 de agosto de 2024
Perfect
Customer
Comentado en Australia el 11 de febrero de 2024
it was easy to cut to size. I added an aluminum flat to both sides (using the sticky tape) which meant I could sit it in place, opened out, and it stays there. I can close the fan and take it down to clean the window. Win win.
Fathima A
Comentado en Australia el 26 de junio de 2023
Not easy to install and very flimsy material, does not suit the purpose at all. Disappointed with this purchase.
dgollodi
Comentado en Canadá el 23 de septiembre de 2021
We have been struggling to find a light blocking blind for our 1/2 circle window in our bedroom. We've tried various things, but this one is a game changer. If you're looking for a darkening blind, look no further!
Productos recomendados