No hay artículos en el carro
No hay artículos en el carroIncluye: montaje en V acolchado, herramientas de montaje e instrucciones (idioma español no garantizado).
C. Geary
Comentado en los Estados Unidos el 28 de mayo de 2023
Yes, this does make a very stable ladder on a tree. I have a 28 ft ladder & it's very scary to climb up to the top with the top of the ladder wiggling back & forth. This really helps a lot. Make sure you also tie the top of the ladder to the tree with a strap just to be safe. I was impressed at the engineering of this accessory. It's designed to make your assembly easier by making the frame hold the locknuts still while you tighten the bolts from the outside. That was a very nice touch & much appreciated.The instructions DON'T tell you everything you need to know to assemble the v-rung correctly. There's 2 triangles you must mount onto the rung & they are not symmetrical. It's very easy to just assemble them according to the illustrations, install it onto the top of the ladder, then run the extension ladder up the tree only to find out the v-rung is 180⁰ off. So then you have to take the ladder down, remove the v-rung, & try again. My suggestion is, when installing on the ladder, make sure that the v-rung is pointing upward towards the tree at about a 45⁰ angle. They don't tell you anything about that in the instructions because they assume everyone knows that. Be forwarned.
Pascal
Comentado en Canadá el 4 de agosto de 2020
I had to tweak it to fit my Feather Lite Ladder, but it works great! I used it a few times and it's very stable and grips to the tree or pole. Great feature to add! I do recommend this product!
Jeremy
Comentado en Canadá el 30 de agosto de 2020
Great for painting exteriors. Rests easily on corners and still feels safe.
Marvin
Comentado en los Estados Unidos el 4 de julio de 2020
I needed to get into trees higher than typical step adders allow and stumbled across this product. My Werner aluminum extension ladder side rails are 1/2" wider distance than the new V-rung adjustment allows and I had to modify the install.- First I used the included pre-drilled plates as a template for the new mounting I required and drilled the holes perpendicular to top of the side rails and parallel to the ladder's scuff guard end cap.- Second- I assembled the new V-rung (left side to left side, right side to right side) and discovered the mounted angle was towards the bottom of the ladder instead of angled towards the top. This simply requires flipping the whole assembly side-to-side and now the angle is correct.- Third I added 1/4" of aluminum flat stock to each side between the new V-rung assembly and ladder side rails to make up for the greater width of my ladders rungs. This also required replacement of the mounting screws with 1" long #10 stainless and nyloc nuts.I was in 4 trees this morning at a ladder height of 14' above ground and the ladder was very stable. Note I also strapped the ladder to the tree using a small load binder strap 3' down from the top of the ladder to ensure safety.
J-man
Comentado en Canadá el 16 de octubre de 2020
Works great, feel very comfortable up poles now
Productos recomendados
Mex $1,988.75
Mex $ 954 .00 Mex $954.00
Mex $320.00
Mex $ 144 .00 Mex $144.00